Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

view cross section mesh

Posted 18.01.2017, 05:50 GMT-5 Mesh 3 Replies

Alex Moreno Bellostes
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I need to see the mesh of an inner element of a cylinder, then I want to make cut in longitudinal section, how can I do it.
Thank you
3 Replies Last Post 18.01.2017, 11:53 GMT-5
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 18.01.2017, 11:08 GMT-5
Hello Alex,
You do that by adding a Filter to your Mesh plot, see e.g. www.comsol.com/community/forums/general/thread/121691
Best,
Jeff
Hello Alex, You do that by adding a Filter to your Mesh plot, see e.g. https://www.comsol.com/community/forums/general/thread/121691 Best, Jeff
Alex Moreno Bellostes
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 18.01.2017, 11:23 GMT-5
Hi, thanks for all,

i had problems because the units of bolean are meters and i'mworking with milimeters
Hi, thanks for all, i had problems because the units of bolean are meters and i'mworking with milimeters
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 18.01.2017, 11:53 GMT-5
OK. I presume you've figured by now that you can use square brackets to denote units, so you can use something like

y<20[mm]

as a filter if you don't want to do the conversion "manually" to y<.02.
Jeff
OK. I presume you've figured by now that you can use square brackets to denote units, so you can use something like y

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content