Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Ports

Posted 17.11.2016, 09:23 GMT-5 RF & Microwave Engineering, Wave Optics, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 5.2, Version 5.2a 0 Replies

Eugene Cheypesh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear comsol community,

I have a question regarding defining diffraction orders in Ports.

Is it enough to specify maximum frequency and push "Compute diffraction orders"?

I am asking because in the "Plasmonic_wire_grating", which I downloaded from this site, there were 4 diffraction orders for each port. But when I deleted them and tried to use "Compute diffraction orders" option, it computed only 1 diffraction order for each port - +1 and -1.

Thanks in advance.

Regards,
Eugene
0 Replies Last Post 17.11.2016, 09:23 GMT-5
COMSOL Moderator

Hello Eugene Cheypesh

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content