Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

ERROR IN LUMPED PORT SETUP

Posted 25.08.2016, 07:53 GMT-4 RF & Microwave Engineering 0 Replies

Bundega Martins Gbayan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello.

I am having challenges to simulate a microstrip transmission line in COMSOL 4.3b.

I have designed the entire geometry and have assigned parameters and materials to each surface/domain.

As far as I can tell everything is alright and the structure is ready for simulation.

But when ever I run it the errors below

"Error in uniform lumped port setup.
-Feature: Lumped port 1 (lport1)
Error in uniform lumped port setup.
-Feature: Lumped port 2 (lport2)"

is thrown. Can somebody please help me to resolve this challenge? Attached in this post is a screen short of the error message
0 Replies Last Post 25.08.2016, 07:53 GMT-4
COMSOL Moderator

Hello Bundega Martins Gbayan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content