Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Modeling of Contact Problems in Solid Mechanics
Posted 08.03.2016, 06:35 GMT-5 Structural Mechanics Version 5.0 1 Reply
Please login with a confirmed email address before reporting spam
I need to know if contact modeling in COMSOL (by using either the penalty or the lagrangian method)
is based on node-to-node or surface-to-surface contact, because it profoundly affects
the penetration of the contact pairs and the accuracy of the simulation.
is based on node-to-node or surface-to-surface contact, because it profoundly affects
the penetration of the contact pairs and the accuracy of the simulation.
1 Reply Last Post 08.03.2016, 12:22 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
9 years ago
Hi,
The formulation is distributed, so I presume that is what you mean by a surface-to-surface formulation. The equations are formed by a numerical integration over the destination boundary, so effectively the gap distance is measured from the Gauss points on the destination boundary.
Regards,
Henrik
The formulation is distributed, so I presume that is what you mean by a surface-to-surface formulation. The equations are formed by a numerical integration over the destination boundary, so effectively the gap distance is measured from the Gauss points on the destination boundary.
Regards,
Henrik