Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Applying voltage to PM machine in 2D
Posted 10.07.2015, 09:46 GMT-4 Low-Frequency Electromagnetics 1 Reply
Please login with a confirmed email address before reporting spam
Hi everyone.
I'm working on a project in which I'm modeling a PM motor.
My question is if anyone knows a method for applying a voltage potential directly onto the stator windings of the machine while modeling in 2D, instead of going via the current density? Applying a current density will not yield valid results in my model as I am assessing the transient responses of the machine.
Cheers
Ole
I'm working on a project in which I'm modeling a PM motor.
My question is if anyone knows a method for applying a voltage potential directly onto the stator windings of the machine while modeling in 2D, instead of going via the current density? Applying a current density will not yield valid results in my model as I am assessing the transient responses of the machine.
Cheers
Ole
1 Reply Last Post 23.07.2015, 11:57 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
9 years ago
Hi,
If you model the stator winding as a "Multi-Turn Coil" feature in 2D, you should be able to choose a Voltage excitation options in addition to the Current or Circuit excitation. Note that if you are modeling only a sector, for example, a 90 degree sector, the input voltage applied for a sector should be 1/4th of the total input voltage to the stator winding.
Hope this helps.
Best Regards,
Nirmal Paudel
COMSOL Employee
USA
If you model the stator winding as a "Multi-Turn Coil" feature in 2D, you should be able to choose a Voltage excitation options in addition to the Current or Circuit excitation. Note that if you are modeling only a sector, for example, a 90 degree sector, the input voltage applied for a sector should be 1/4th of the total input voltage to the stator winding.
Hope this helps.
Best Regards,
Nirmal Paudel
COMSOL Employee
USA