Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Extruding a 2-D Geometry / Bullnose Creation
Posted 19.05.2010, 18:29 GMT-4 0 Replies
Please login with a confirmed email address before reporting spam
I am performing a simulation of turbulent flow over a flat plate with a blunt leading and trailing edge. I would like to add a rounded nose to this plate and make it a 3-D problem by extruding it.
My Procedure:
Create the plate rectangle (2-D)
Draw the circle in the correct location at the leading edge (2-D) -- *****the radius of the circle is 0.000635 m******
extrude a distance of 1 for example
When I do this the circle becomes a square cylinder!! How can I work around this issue?
Thanks
Markthomas
Hello Markthomas Cutone
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.