Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
grid number limitation in Postinterp?
Posted 11.03.2010, 05:58 GMT-5 0 Replies
Please login with a confirmed email address before reporting spam
I have a question about Postinterp command when I tried to output my result into Matlab.
I tried to output the spatial distribution of my result into Matlab, so I use Postinterp to make the interpolation in 3D space. When the size of grid point is 200*200*200, I can obtain the result in about one minute, but when I further increase the size to 400*400*400, the error message occur: Internal Error JNI
I have no idea what this means, and guess there is the mesh grid size limitation.
Then I check the properties of Postinterp in "Reference Guide", and found the definition of Blocksize: determining the number of mesh elements that are assembled together in a vectorized manner (default value 5000).
My question is : to enhance the accuracy of output, how can I further increase the mesh grid size in Postinterp? And is there the relation between Blocksize and limitation of mesh grid size?
Thanks in advance.
Yao
Hello Yuanzhao Yao
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.