Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Using a built in physics interface

Rahul Kishor Semiconductors

Please login with a confirmed email address before reporting spam

Hi All,

I have a modified equation for the fluid continuity equation based on the perturbation expansion. The modified eqn is:

d(rho_1)/dt + rho_0 * div (v_1) = 0 (also attached the eqn in the png file)....

so according to the equation we have two density variables .......where rho_0 is a constant.....

But in any fluid model in COMSOL the continuity equation is d(rho)/dt + rho * div (v_1) = 0 , where the density is the same for the first and second term of the equation......

Should I make use of the PDE interface to model this physics?

Could someone please help me with this.

Thanks in advance

Regards,
Rahul Kishor

0 Replies Last Post 26.02.2013, 05:23 GMT-5
COMSOL Moderator

Hello Rahul Kishor

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.