How to use sens.v for switch

Please login with a confirmed email address before reporting spam

Hi,

I am currently using the subcircuit definition in the Electrical Circuit (cir) module and I am confused as to how I am supposed to define the on and off conditions for the "switch" component. To define it, COMSOL says to define the condition as a function of 'sens.v' but when I try to state a condition as the following (without any quotations),

"sens.v"

, it states that there is an "unknown variable sens.v". Can anyone show me an example of how to state the function so that sens.v is the measured node where measure(+) is a and measure(-) is b?

Thanks in advance!



1 Reply Last Post 13.09.2024, 14:19 GMT-4
COMSOL Moderator

Hello Kiran Seetala

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 4 days ago 13.09.2024, 14:19 GMT-4

Did you figure this out?

I find the comsol electric circuit module pretty brutal and not a lot of people using it it seems

I can't get a switch to open and it seems I am not the only one. However all comsol posts with this issue have no replies

Did you figure this out? I find the comsol electric circuit module pretty brutal and not a lot of people using it it seems I can't get a switch to open and it seems I am not the only one. However all comsol posts with this issue have no replies

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.