Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

about doubt about amgnetic ferrite core

Posted 20.11.2012, 10:38 GMT-5 Low-Frequency Electromagnetics, Geometry, Mesh Version 4.3 1 Reply

kishore naik
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all ,
i have small doubt , how to apply ferrite core to coil and model the geometry , in attached model , i created a rectangular and iron and renamed and changed a relative permeability of 1500 , i already defined the analytical parameters like magnetic field intensity and mutual inductance in the parameters , i need to verify the same by the simulation model, but i made a model applied all parameters , i am not getting proper value ?
is it is problem of geometry , if so let me know how to make ferrite core to the coil, and extract values correctly
I think problem with geometry and meshing only ...please let me know
Thanks in advance
I am attching my model

--
kishore Naik Mude
1 Reply Last Post 21.11.2012, 03:56 GMT-5
kishore naik
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 21.11.2012, 03:56 GMT-5
pls reply

--
kishore Naik Mude
pls reply -- kishore Naik Mude

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content