Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Exciting batch mode while keeping parametric results
Posted 23.10.2012, 11:51 GMT-4 Studies & Solvers Version 4.2, Version 4.2a, Version 4.3, Version 4.3a 1 Reply
Please login with a confirmed email address before reporting spam
Hello all,
I am faced with a problem. I launched a batch calculation on a file where I forgot to remove one study step.
The first one is parametric and had finished without trouble.
The second one is eigenvalue, and seems to be stuck.
I want to exit the batch calculation while keeping the results of study 1 (parametric).
Is there a way to do that?
(the outputfile being written at the end, if I stop right now, I loose everything)
[EDIT] : I should specify that I am talking about batch mode with a console, not with the GUI.
I am faced with a problem. I launched a batch calculation on a file where I forgot to remove one study step.
The first one is parametric and had finished without trouble.
The second one is eigenvalue, and seems to be stuck.
I want to exit the batch calculation while keeping the results of study 1 (parametric).
Is there a way to do that?
(the outputfile being written at the end, if I stop right now, I loose everything)
[EDIT] : I should specify that I am talking about batch mode with a console, not with the GUI.
1 Reply Last Post 24.10.2012, 10:53 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
I don't think you can tell the batch job to save the file. But one could try and see if there's a recovery file corresponding to the batch job. There should be one unless automatic recovery is turned off; default is on. Then open the recovery file (from the File menu in the GUI) and save under a different name.