Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Problem in revolving 2D result to 3D
Posted 27.09.2012, 06:02 GMT-4 Low-Frequency Electromagnetics Version 4.3 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I am working on 2D AC/Dc module. I have simulated a coil and I want to see its 3D view. I chose a new data set and selected domains but when I try to revolve 2D into 3D it give me error as" Data may not cross the axis of revolution.
I am working on 2D AC/Dc module. I have simulated a coil and I want to see its 3D view. I chose a new data set and selected domains but when I try to revolve 2D into 3D it give me error as" Data may not cross the axis of revolution.
1 Reply Last Post 27.09.2012, 08:59 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
I assume that this error message comes from the fact that a 2D axi into 3D by revolution requires, in COMSOL, that all your domains are to ONE side of the axis of rotation.
Just as in 2D-Axi, you should never have anything drawn (when finished) in the left side of the R<0 region
--
Good luck
Ivar
I assume that this error message comes from the fact that a 2D axi into 3D by revolution requires, in COMSOL, that all your domains are to ONE side of the axis of rotation.
Just as in 2D-Axi, you should never have anything drawn (when finished) in the left side of the R<0 region
--
Good luck
Ivar