Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Active noise control using Matlab R2015a and COMSOL Multiphysics 5.6

Please login with a confirmed email address before reporting spam

Greetings,

I am using Matlab 2015a and COMSOL Multiphysics 5.6 combined for simulation of active noise control. Actually, I am using the function for Impulse response in Matlab I am sending in attachment, and try to import it into COMSOL, but I keep getting the same error I am sending in attachment as well. My question is, is it something wrong with the function defined (which I believe is not the case, because the code goes correctly in Matlab and I even get the graph) or is it something I do wrong in COMSOL?

I would appreciate your answers. Thank you in advance! Maja



0 Replies Last Post 27.03.2022, 14:54 GMT-4
COMSOL Moderator

Hello Maja Anachkova

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.