Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

2d,3d modeling with joule heating

Posted 02.11.2011, 11:09 GMT-4 Heat Transfer & Phase Change, Structural Mechanics 3 Replies

Art
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have a plastic plate with a silver circuit printed on it., Almost everything is scaled inches.

However the thickness of the silver circuit it 100 nanometers.

Five volts dc in silver circuit.

This is impossble to mesh in 3D because of the extreme aspect ratio.

I tried putting it 2D with 2D elements on the 3D plate mesh, but can't do it as it stands.

Also in a 3D model I cannot specify the thickness of the 2D elements.

Also would appreciate other advice how to go about joule heating with this kind of a circuit.

Normally just using the joule heating options would do the trick, but I am not sure about this one.

--
Arthur Rupel

Attachments:

3 Replies Last Post 02.11.2011, 18:44 GMT-4
Nagi Elabbasi Facebook Reality Labs
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 02.11.2011, 14:50 GMT-4
Use shells (available under Structural Mechanics) instead of 2D or 3D solids.
Use shells (available under Structural Mechanics) instead of 2D or 3D solids.
weichih Lin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 02.11.2011, 15:49 GMT-4

Thanks and I will retry again. Two years ago I had the same problem.
Thanks and I will retry again. Two years ago I had the same problem.
Art
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 02.11.2011, 18:44 GMT-4
Thanks, this will prevent me from banging my head on the desk.

Art

--
Arthur Rupel
Thanks, this will prevent me from banging my head on the desk. Art -- Arthur Rupel

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content