Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
About microwave heating problem
Posted 01.09.2011, 12:26 GMT-4 RF & Microwave Engineering, Heat Transfer & Phase Change Version 4.2 1 Reply
Please login with a confirmed email address before reporting spam
I am trying to do microwave heating simulation of a simple rectangular waveguide.
I would like to calculate temperature distribution of copper due to microwave power transmission.
Input power is 10kW, and Frequency-Stationary is used for study type.
EM simulation result could be obtained with this simulation setup in the attached file.
My problem is, however the Temperature result is not available with this setup.
Since I am new to this area, would anyone help me to find a right setup for microwave heating?
I attach my simulation file created in COMSOL 4.2 version.
Thank you so much. I would really appreciated if you give me a clue.
Regards, Ki
Attachments:
Hello Ki Shin
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
Rather than using the RF module, try using Heat Transfer>Electromagnetic Heating>Microwave Heating (mh)
I think that will give you more what you are looking for!
Cory