Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Help Regarding Modelling and Simulation of Gas sensor for detection of harmful gases

Posted 23.11.2018, 10:49 GMT-5 Electromagnetics, Semiconductor Devices, Heat Transfer & Phase Change Version 5.4 0 Replies

DEEPAK BHADU
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

sir, I want to model and simulate gas sensor for detection of some harmful gas but found some problem as follow:

  1. How to made sensor with given specification of material and thickness on substrate?
  2. how to draw temperature - voltage curve in COMSOL?
  3. how to draw Time -resistance curve at different ppm of harmful gas?
  4. how to place sensor in bottom in Exposure model ?
  5. how to simulate response -concentration curve in COMSOL?

  6. how to write and used Navier-stoke eqn, poission eqn and write boundary condition for exposure , heat transfer, electrical condition?

    A little help could means a lot for me and any other suggestion are welcomed. Thanks in advance for help .

0 Replies Last Post 23.11.2018, 10:49 GMT-5
COMSOL Moderator

Hello DEEPAK BHADU

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content