Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Need to change units of concentration

Posted 30.09.2018, 10:10 GMT-4 Structural & Acoustics, Chemical, General Version 5.1 2 Replies

Inayeth Ali
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am using the transport of diluted species module to simulate drug diffusion through the eye.

I need to give the concentration of the drug in the eye ball in terms of mg/cm3 but comsol is accepting values only in Moles/cm3

How do I get the software to accept values in mg/cm3?

2 Replies Last Post 02.10.2018, 05:58 GMT-4
Edgar J. Kaiser Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 6 years ago 30.09.2018, 13:08 GMT-4
Updated: 6 years ago 30.09.2018, 14:25 GMT-4

C[mol/cm3] = C[mg/cm3]/(M[g/mol]*1000[mg/g])

Of course you need to know the molecular mass M of that drug.

-------------------
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
C[mol/cm3] = C[mg/cm3]/(M[g/mol]*1000[mg/g]) Of course you need to know the molecular mass M of that drug.
Inayeth Ali
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 6 years ago 02.10.2018, 05:58 GMT-4

Thanks a lot!

Thanks a lot!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content