Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Winding Direction in Coil Geometry

Please login with a confirmed email address before reporting spam

Hi,

After drawing a chunck block, I set this block as a homogenized multi-turn coil with circular coil-type. Then I need to select edges with a consistent direction to make it work as the coil.

The only problem is, only one edge element shows opposite direction. Does anybody can fix this kind of problem?



1 Reply Last Post 17.01.2018, 05:59 GMT-5

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 17.01.2018, 05:59 GMT-5

Since this is a closed-loop non-circular coil, you may want to change to "numeric coil" type, and specify the input using internal boundary orthogonal to the coil direction.

Since this is a closed-loop non-circular coil, you may want to change to "numeric coil" type, and specify the input using internal boundary orthogonal to the coil direction.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.