Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

drawing a magnified deformation

Posted 23.03.2011, 00:02 GMT-4 Results & Visualization Version 4.0, Version 4.0a 1 Reply

Behrooz Rezaeealam
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello

i want to draw a magnified bending (caused by bending load) to have a visible bending (for example such as a cantilever).
i was wondering if it is possible by comsol?
thanks for your helps
behrooz
1 Reply Last Post 23.03.2011, 02:08 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 23.03.2011, 02:08 GMT-4
Hi

yous in V4 by default "deformations" are off, if you right click on the Plot Group Surface node you can add a deformation node. Then you can use the default scale or define your own

--
Good luck
Ivar
Hi yous in V4 by default "deformations" are off, if you right click on the Plot Group Surface node you can add a deformation node. Then you can use the default scale or define your own -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content