Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Concentric Pipes flow

Posted 09.06.2017, 09:23 GMT-4 2 Replies

Erhamah Alsuwaidi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to simulate fluid flow through two concentric pipes. My model runs properly for low velocities (0.0005 M/S) but not higher once (0.5m/s). Attached are some pictures of the model. Please assist me.

Attachments:

2 Replies Last Post 11.06.2017, 12:42 GMT-4
Mohammad Amin Kazemi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 10.06.2017, 21:06 GMT-4
Updated: 7 years ago 10.06.2017, 21:06 GMT-4
Erhamah,
Have you tried smoothed increase of inlet velocity?
I mean solve it for 0.0005 m/s, use the solution as an initial condition for let's say 0.001 m/s and so forth.
You may also use a parametric sweep study.
Amin,
Erhamah, Have you tried smoothed increase of inlet velocity? I mean solve it for 0.0005 m/s, use the solution as an initial condition for let's say 0.001 m/s and so forth. You may also use a parametric sweep study. Amin,
Erhamah Alsuwaidi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 11.06.2017, 12:42 GMT-4
Thanks for your reply!

I will try your approach and will let you know. Thanks again!
Thanks for your reply! I will try your approach and will let you know. Thanks again!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content