Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Is it possible to remove/delete mesh or separate nodes?

Posted 09.09.2016, 01:07 GMT-4 Low-Frequency Electromagnetics, Charged Particle Tracing, Particle Tracing for Fluid Flow, Mesh Version 4.3a 0 Replies

Tribeni Roy
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, I am trying to simulate material removal by using pulsed electric field. I have used deformed mesh. Condition is if ec.normE is greater than a particular value, the mesh deforms. However, everytime inverted mesh problem occurs. I have tried with finer mesh, time step reduction, adaptive mesh and automatic remesh, but to no avail. I also want to know if its possible to remove material (mesh removal or node separation) from a particular position due to the condition. Do I have to write an explicit code to be able to remove material?? I have seen only 1 paper using Comsol that indirectly removes material by hiding the area above threshold value. Is it the proper way? I also need to further generate particles at those locations where material removal takes place. Can anyone guide me in this respect?
0 Replies Last Post 09.09.2016, 01:07 GMT-4
COMSOL Moderator

Hello Tribeni Roy

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content