Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

initial condition

Posted 16.12.2010, 06:25 GMT-5 Fluid & Heat, Results & Visualization Version 4.0 1 Reply

Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear All,
it is possible to save and see the initial conditions imposed in the domain before the simulation?

thanks
1 Reply Last Post 16.12.2010, 10:05 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 16.12.2010, 10:05 GMT-5
Hi

in 3.5 you have the solve for inirtial conditions.

in V4 its "compute to selected" whe rightclicking on the Stationary, Transient, Eigenvalue,... SUB-node lowest level)

--
Good luck
Ivar
Hi in 3.5 you have the solve for inirtial conditions. in V4 its "compute to selected" whe rightclicking on the Stationary, Transient, Eigenvalue,... SUB-node lowest level) -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content