Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How can I add the "PAN" button to the Graphic window of comsol?

Posted 03.06.2016, 05:54 GMT-4 Simulation Apps, Geometry Version 5.2 2 Replies

Richard Storm
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am new and I expect I can add or customize buttons like in Solidworks or Inventor to the Graphics window. I could not find that in the manual. Thank you
2 Replies Last Post 03.06.2016, 11:11 GMT-4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 03.06.2016, 08:52 GMT-4
In COMSOL, you pan by pressing the right mouse button while moving the mouse.
Best,
Jeff
In COMSOL, you pan by pressing the right mouse button while moving the mouse. Best, Jeff
Richard Storm
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 03.06.2016, 11:11 GMT-4
Thank you Jeff, Since sometimes I use laptop and touchpad it is a little bit un-userfriendly to use that method especially if I repeat it a lot, I am looking for adding the button there. It also makes it easier for some models plus navigating in the results section.
Thank you Jeff, Since sometimes I use laptop and touchpad it is a little bit un-userfriendly to use that method especially if I repeat it a lot, I am looking for adding the button there. It also makes it easier for some models plus navigating in the results section.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content