Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Biomechanics, knee joint

Mikkel Nyløkke Stengaard

Please login with a confirmed email address before reporting spam

Im currently working on a model where im trying to simulate the forces acting on articular cartilage of the knee joint, specifically the tibiofemoral joint.

Its a rather complex model. I would like to have a frictionless contact between the menisci and the cartilage surfaces. im trying to solve this prolem by using assembly and then contact pairs. But my model is not able to converge. All parts are in contact before the load is applied. Is it correct to use contact pairs in this scenario?
If i use identity pairs and continuity, the model is able to converge, but im not sure thats the right way to go?


0 Replies Last Post 07.03.2016, 04:38 GMT-5
COMSOL Moderator

Hello Mikkel Nyløkke Stengaard

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.