Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Coupling problem in modelling Electristaically actuated MEMS switch

Please login with a confirmed email address before reporting spam

Hi,

I am trying to model electrostaic MEMS switch fixed at the two ends in comsol 4.3 by coupling es+ale+solid. For this, I have grounded one plate and applying a voltage on the other, air boundary is selected for moving mesh and force induced due to es physics is used for boundary load. But, I am not getting any displacement as error occurs after computation. Please help me. Also, I don't have access of higher version of comsol so, I can not use electromechanical physics.
I have attached the model.

Regards,
Vasudha


0 Replies Last Post 06.03.2016, 00:45 GMT-5
COMSOL Moderator

Hello Vasudha Agrawal

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.