Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Cannot get Creep Strain with reasonable Creep Strain Rate? time integration stopped ?

Please login with a confirmed email address before reporting spam

Hello all, I have been struggled with a weird problem for quite a while:

I am using a user-defined Creep rate tensor in the the Solid Mechanics Module, in order to simulate material response that depends on strain rate.

I works well for most of the time, but recently, sometimes when I apply a boundary load on the model in my time-dependent problem, the model gets very reasonable creep strain rate (inelastic) at each iteration, but the creep strain is always zero at every time step.

It seems COMSOL has stopped doing the time integration of the creep strain rate in order to get the creep strain.

I am wondering at the cause of this problem, and how can I solve it ? Is it due to any special setting in the solver ?

Thank you so much for your help.

Best regards,
G.Lu


0 Replies Last Post 26.02.2016, 17:18 GMT-5
COMSOL Moderator

Hello Gongda Lu

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.