Sehen Sie, wie die Multiphysik-Simulation in Forschung und Entwicklung eingesetzt wird
Ingenieure, Forscher und Wissenschaftler aus allen Branchen nutzen die Multiphysik-Simulation, um innovative Produktdesigns und -prozesse zu erforschen und zu entwickeln. Lassen Sie sich von Fachbeiträgen und Vorträgen inspirieren, die sie auf der COMSOL Conference präsentiert haben. Durchsuchen Sie die untenstehende Auswahl, verwenden Sie die Schnellsuche, um eine bestimmte Präsentation zu finden, oder filtern Sie nach einem bestimmten Anwendungsbereich.
Sehen Sie sich die Kollektion für die COMSOL Conference 2024 an
Friction Stir Welding (FSW) has gained much importance throughout the last years. Beside comprehensive experimental work that has been carried out, the simulation of the welding zone is of major interest. Due to the high strains observed within the welding zone, the Eulerian (CFD) ... Mehr lesen
A dynamic mathematical model, based on physical and transport properties and mass and energy balances, was developed for the simulation of unsteady convective drying of agricultural products (fruits and vegetables) in static bed conditions. The model utilizes water sorption isotherm ... Mehr lesen
We are developing approximations of electrically anisotropic materials for use in novel imaging methods. Our modeling work in COMSOL comprises comparisons of anisotropic and layered models in terms of electrical conductivities measured using different strategies. We tested solution ... Mehr lesen
In this work, we present simulations of a novel micromachined calorimetric flow sensor using COMSOL Multiphysics. The sensor is based on four germanium thermistors that serve as heat sources and as temperature sensors simultaneously. In operational mode, the heated membrane is cooled by ... Mehr lesen
This paper presents the mathematical modeling for the analysis of the magnetostrictive materials, which describes the behaviour of the magneto-mechanical coupling in a rod of magnetostrictive material and capturing it in COMSOL® to produce a predictive and detailed analysis. A simulation ... Mehr lesen
The corrosion at cut-made edges is significant due to the anode to cathode surface ratio in this region. The major problems are the risks of red rust appearance at the exposed steel surface, and the risks of paint delamination in case of insufficient corrosion protection. The work ... Mehr lesen
Clarifiers are used to separate sludge and water in waste water treatment plants. In this paper we analyze a malfunctioning clarifier using the mixture model. We are able to receive model results that are reasonably close to measurements from the real clarifier. With the model we can ... Mehr lesen
Temperature and residual moisture content of a stationary Textile in a home tumble dryer are simulated in a 2D model with COMSOL Multiphysics. Moisture migration to the textile surface is modeled in the form of capillary flow and vapor diffusion along with heat transfer in the form of ... Mehr lesen
Phosphoric acid doped polybenzimidazole (PBI) membranes are commonly used in today’s high-temperature polymer-electrolyte-membrane (HTPEM) fuel cell technology. COMSOL Multiphysics is used to model and simulate the three-dimensional, single-phase, non-isothermal overall cell behaviour ... Mehr lesen
Cantilever vibration modes were simulated with COMSOL Multiphysics. In the 1st approach the model consisted of an excitation piezo, a holder plate and a chip where the cantilever was mounted on. A sinusoidal voltage signal was applied to the piezo in the simulation, which resulted in ... Mehr lesen