Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Closed and Open Ends of Tube - Acoustics

Posted 07.01.2016, 16:35 GMT-5 Acoustics & Vibrations, Geometry, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 5.1, Version 5.2 0 Replies

Thomas Caley
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am modeling a set of tubes for an Eigenfrequency study. Within the Pressure Acoustics Frequency Domain node, I let Comsol apply the automatic Sound Hard Boundary condition to all walls. I then applied a Sound Soft Boundary to the outlet face.

Does this correctly simulate a tube with a closed inlet boundary and open exit end? I have found very little in the documentation covering what I hope are straightforward settings.

Thanks,
Thomas
0 Replies Last Post 07.01.2016, 16:35 GMT-5
COMSOL Moderator

Hello Thomas Caley

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content