Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Simulating induction from a wire to a coil
Posted 19.07.2015, 05:36 GMT-4 Version 5.0 1 Reply
Please login with a confirmed email address before reporting spam
Hello community,
I am new to Comsol and try to make my first steps.
I want to simulate the induction of current from a live wire into a printed coil on a circuit board.
The coil is a few centimeters above that wire so it must be in 3d.
I added a picture to show what i mean.
Are there any tutorials that are similar to my problem?
Thank you for your help and suggestions!
I am new to Comsol and try to make my first steps.
I want to simulate the induction of current from a live wire into a printed coil on a circuit board.
The coil is a few centimeters above that wire so it must be in 3d.
I added a picture to show what i mean.
Are there any tutorials that are similar to my problem?
Thank you for your help and suggestions!
Attachments:
1 Reply Last Post 03.08.2015, 14:26 GMT-4