Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

4.0 Dielectric Scattering

Posted 07.08.2010, 14:44 GMT-4 0 Replies

Tsuwei Tan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello. I'm working on the 3.5 dielectric scattering tutorial and trying to reproduce the results in the 4.0 comsol. I have attached jpgs of my results (which are not correct) as well as my model. Basically I'm missing some step in the porting process. Its a very simple model and problem to set up but I'm unable to figure it out because the tutorial is written for 3.5. If anyone has a few minutes and could look over my model and give any advice I'd me much appreciative.
0 Replies Last Post 07.08.2010, 14:44 GMT-4
COMSOL Moderator

Hello Tsuwei Tan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content