Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

using symmetry on single coil domain-benchmark test

Posted 22.04.2015, 05:04 GMT-4 Low-Frequency Electromagnetics Version 5.0 0 Replies

David Segal
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

I compare 2 cases :1. A single coil (torus with gap feed) -magnetic flux density at center matches theory.
2. Half a torus (180 degree section) "stuck " to a magnetically insulated plane boundary fed by a terminal and ground)
Symmetry dictates that cases 1 and 2 should give the same result (actually case 2 should give half the value of case 1?)

Result :magnetic flux in case 2 is 25% lower than case 1

Please help

David
0 Replies Last Post 22.04.2015, 05:04 GMT-4
COMSOL Moderator

Hello David Segal

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content