Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Results: how to set the total displacement in 3D plotting to be more realist?

Posted 09.04.2015, 04:34 GMT-4 Structural Mechanics 1 Reply

Jintao Shen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have got some stress and displacement results from Solid Mechanics simulation. However, the shown plotting in total deformation is over exaggerated by maybe 10000 times. Is there any way to adjust the final plotting that the total deformation looks more realistic?
regards
1 Reply Last Post 10.04.2015, 15:16 GMT-4
Andrew Vamos
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 10.04.2015, 15:16 GMT-4
When you tell Comsol to include deformations, if you look at the options provided underneath that deformation tab, there is a scale factor there. Deselect this, or simply manually set it equal to 1.
When you tell Comsol to include deformations, if you look at the options provided underneath that deformation tab, there is a scale factor there. Deselect this, or simply manually set it equal to 1.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content