Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Transient analysis using batch mode, only time = 0 result is saved?
Posted 21.06.2010, 09:27 GMT-4 2 Replies
Please login with a confirmed email address before reporting spam
Hi!
I am using batch mode in linux to run a model using following command,
comsol -np 4 batch -input fileinput.mph -output fileinputRes.mph
It's a transient model, after running the model, a new file fileinputRes.mph is created, but the problem is,
only the results are time = 0 is saved, results for other times are not saved.
And it's the same problem with parametric model, only results for the first values of parameter is saved.
Does someone has the same experience as me?
Any suggestions would be appreciated.
Thanks a lot.
Li
I am using batch mode in linux to run a model using following command,
comsol -np 4 batch -input fileinput.mph -output fileinputRes.mph
It's a transient model, after running the model, a new file fileinputRes.mph is created, but the problem is,
only the results are time = 0 is saved, results for other times are not saved.
And it's the same problem with parametric model, only results for the first values of parameter is saved.
Does someone has the same experience as me?
Any suggestions would be appreciated.
Thanks a lot.
Li
2 Replies Last Post 14.07.2010, 13:13 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
I'm fighting with exactly the same problem. If you ever find a solution for this, please do share that =)
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
I'm fighting with exactly the same problem. If you ever find a solution for this, please do share that =)
Sorry, I haven't found the solution yet.