Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Time Dependent flow model, HELP! Mr. Ivar!
Posted 25.02.2015, 03:01 GMT-5 Fluid & Heat, Geometry, Materials, Mesh, Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization, Studies & Solvers Version 4.3, Version 4.4 0 Replies
Please login with a confirmed email address before reporting spam
I created a cross section of a pancreas denoted by a rectangle with two circles in it denoting islets, which secrete insulin.
My model is based off a paper written by peter buchwald.
Here are my parameters :
R_max reaction max of glucose
R_max1 reaction of glucose in first phase
V_in inlet velocity
C_Hf half velocity of concentration
I'm stuck on having a secretion of insulin from those two circles. Everytime i run comsol, it show only laminar flow but does not show the insulin secretion. I tried putting outlets on the circles and then a concentration and flux but that didn't work either. Can someone help me please!
Hello Sherman Ondelise
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.