Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

out of memory

Posted 06.02.2015, 04:52 GMT-5 5 Replies

Luo Xiaojun
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all, I'm a new user in COMSOL 5.0. I'm trying to run the example in Batteries and Fuel Cell Module (sofc_unit_cell), but encountered the following problem:

Failed to find a solution for the initial parameter.
Segregated group 2

Out of memory during LU factorization.
In segregated group 2:
Returned solution is not converged.
- Feature: Stationary Solver (sol1/s1)

I'd like to see is it due to my computer's low memory? My computer is of 2GB.

Thanks in advance.
5 Replies Last Post 06.02.2016, 03:11 GMT-5
Jim Freels mechanical side of nuclear engineering, multiphysics analysis, COMSOL specialist
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 06.02.2015, 22:42 GMT-5
Yes. You need more memory. It is cheap and worth every penny for COMSOL usage.
Yes. You need more memory. It is cheap and worth every penny for COMSOL usage.
Nisheka Anadkat
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 23.03.2015, 03:13 GMT-4
I am also getting same error. I think memory is the issue. I have 4GB still getting same error.
I am also getting same error. I think memory is the issue. I have 4GB still getting same error.
Yoginder Kumar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 09.04.2015, 08:19 GMT-4
hello friend
goto study>solver configuration>solution> *** solver>direct> out of core>check it and fill the info as per ur system configuration i think it can help u.
plzz give ur feedback.
hello friend goto study>solver configuration>solution> *** solver>direct> out of core>check it and fill the info as per ur system configuration i think it can help u. plzz give ur feedback.
Abdulfatah Abushagur
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 11.05.2015, 12:27 GMT-4
Hello Yoginder Kumar,

I have tried yours and found it works, it was very helpful.

Thanks
Hello Yoginder Kumar, I have tried yours and found it works, it was very helpful. Thanks
Michele Bottarelli
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 06.02.2016, 03:11 GMT-5
Hi there.

The "out of core" advice is new for me. I've tried but without success.

I've a good laptop (i7, 16Gb), and I'm working already with a very coarse mesh.

Any suggestion in setting the "out of core" configuration?

Thanks.
Hi there. The "out of core" advice is new for me. I've tried but without success. I've a good laptop (i7, 16Gb), and I'm working already with a very coarse mesh. Any suggestion in setting the "out of core" configuration? Thanks.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content