Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Bending a piezolectric composite

Posted 11.11.2014, 00:41 GMT-5 0 Replies

Anup Kumar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

Can I bend a piezoelectric composite like the one in attached image, where each end of the sheet is free to move. I tried by applying equal force in opposite directions(y-axis) with a small offset force on both end along z-axis but I get following error.

Failed to find a solution.
The relative residual (2.1) is greater than the relative tolerance.
Returned solution is not converged.

I guess error is because there is a net force along z-axis. Do I need to change force orientation. Please help.

Thanks
Anup Kumar

Attachments:

0 Replies Last Post 11.11.2014, 00:41 GMT-5
COMSOL Moderator

Hello Anup Kumar

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content