Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boundary condition problem

Posted 30.10.2014, 09:40 GMT-4 Plasma Physics Version 4.4 1 Reply

Dawei Liu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

For the 1-D Argon discharge model(dc1), the boundary value of Ar*, Ar+ and electron density, and the voltage at the position of positive electrode was calculated by another model(dc2). It seemed that only electron density and energy density can be defined through Drift diffusion-->Electron density and energy. How do I define the boundary condition of the other species?
1 Reply Last Post 03.11.2014, 10:04 GMT-5
Luke Gritter Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 03.11.2014, 10:04 GMT-5
Dawei,

To specify the values of Ar* and Ar+ at a boundary, right click on the "Species: Ars" node in the model tree and select "Inlet" from the menu. Do the same for Ar+. On the Inlet nodes, you can specify values of these species on the selected boundaries.

--
Luke Gritter
AltaSim Technologies
Dawei, To specify the values of Ar* and Ar+ at a boundary, right click on the "Species: Ars" node in the model tree and select "Inlet" from the menu. Do the same for Ar+. On the Inlet nodes, you can specify values of these species on the selected boundaries. -- Luke Gritter AltaSim Technologies

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content