Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Thermoforming melted polymer

Please login with a confirmed email address before reporting spam

Hello,
I would like to know if it is possible to create a model, in order to mold a massive melted polymer.
The aim is to see the deformation and the pressure inside the product during the forming

I've seen that COMSOL can use non-newtonian fluid flow, but it is not a flow it is just a deformation in non-newtonian mechanics, so which module will you use to do it ?

Thanks.

0 Replies Last Post 07.10.2014, 05:43 GMT-4
COMSOL Moderator

Hello Philippe Mayer

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.