Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Repelling of two magnets on top of two rods

Posted 23.07.2014, 16:38 GMT-4 Low-Frequency Electromagnetics, Structural Mechanics Version 4.4 2 Replies

Edvin Golestanyan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear All,

I have attached a model. Two magnets are on top of two rods and the magnets lets assume they have opposite polarities so they have to repel each other and the rods should deform.

Please help me how can I simulate it, to see the deformation of the rods.

Thank you.
2 Replies Last Post 25.07.2014, 12:20 GMT-4
Sergei Yushanov Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 24.07.2014, 08:41 GMT-4
Edvin,

Attached is your model with deformed rods.
I made several changes:

- Added second “Force Calculation” node, so each force node calculates stress tensor for separate rod (you can’t use single “Force Calculation” node for both rods)
- Added two “Boundary Load” nodes in Solid Mechanics interface to apply Maxwell stress tensor load

Note, this model is valid for small displacements only. If you want to consider large displacements, then Moving Mesh interface (ale) should be added.

Regards,
Sergei
Edvin, Attached is your model with deformed rods. I made several changes: - Added second “Force Calculation” node, so each force node calculates stress tensor for separate rod (you can’t use single “Force Calculation” node for both rods) - Added two “Boundary Load” nodes in Solid Mechanics interface to apply Maxwell stress tensor load Note, this model is valid for small displacements only. If you want to consider large displacements, then Moving Mesh interface (ale) should be added. Regards, Sergei
Edvin Golestanyan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 25.07.2014, 12:20 GMT-4
Sergei,

Thank you very much, you helped me a lot.

Regards,

Edvin
Sergei, Thank you very much, you helped me a lot. Regards, Edvin

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content