Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

User Controlled Mesh across two different geometries

Posted 02.04.2014, 22:31 GMT-4 Mesh Version 4.3b 2 Replies

SIddarth Gangula
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello All,
I am new to COMSOL and would like to get some help with user controlled mesh. Attached is a figure I would like to model in COMSOL. The length is 2cm and the height is 1cm. When I try to use the user defined mesh. It meshes both bodies separately, so I'm unable to get the mesh which is in the figure.
Any help is appreciated.
Thank you

Attachments:

2 Replies Last Post 03.04.2014, 16:19 GMT-4
Pu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 03.04.2014, 02:26 GMT-4
I don't think it's possible to have such mesh in COMSOL.

--
Pu, ZHANG
DTU Fotonik
I don't think it's possible to have such mesh in COMSOL. -- Pu, ZHANG DTU Fotonik
SIddarth Gangula
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 03.04.2014, 16:19 GMT-4
OK. Thanks for the reply.
OK. Thanks for the reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content