Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Difference between defining one weak contribution at several points or several weak contributions with each located at one point

Posted 24.03.2014, 11:54 GMT-4 Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.3, Version 4.3a, Version 4.3b, Version 4.4 0 Replies

Felix
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi Comsol community,

I would like to introduce point sources in equation based simulation. In the simulations the PDE of the system is defined with the help of the weak form. Now I would like to introduce 10 point sources and in principal there are two ways:

1.) Defining one weak contribution and select all 10 points

or

2.) Defining 10 weak contributions, each of them only at one point

Is there a difference between the two methods. And in case that there is a difference, which way is preferable

Thanks a lot in advance,
Felix
0 Replies Last Post 24.03.2014, 11:54 GMT-4
COMSOL Moderator

Hello Felix

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content