Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Photo carrier generation in the Semiconductor Module

Please login with a confirmed email address before reporting spam

I'm trying to figure out how to achieve photo-carrier generation in a direct band gap semiconductor in the COMSOL 4.4 semiconductor module. The only form of generation I see in the module is Impact Ionization which consists of various a,b,c, and d factors for electrons and holes. I need the equivalent of a photo-excitation signal to analyze the IV characteristics of a semiconductor. How can I model the generation of photo-carriers in the semiconductor module?

3 Replies Last Post 04.12.2014, 08:37 GMT-5
COMSOL Moderator

Hello Eric Moore

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 24.07.2014, 16:00 GMT-4
I'm trying to do the same thing. Any luck on coupling the physics?
I'm trying to do the same thing. Any luck on coupling the physics?

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 03.12.2014, 20:11 GMT-5
Generation term is simply included by using User Defined Recombination and setting recombination rate to be negative
Generation term is simply included by using User Defined Recombination and setting recombination rate to be negative

Daniel Smith COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 04.12.2014, 08:37 GMT-5
Hi, there is some new functionality in V5.0 to assist in this type of modeling. You can also refer to this blog entry:

www.comsol.com/blogs/investigating-led-efficiency-via-multiphysics-simulation/

and these new models:

www.comsol.com/model/ingan-algan-double-heterostructure-led-20299
www.comsol.com/model/gaas-pin-photodiode-19705
Hi, there is some new functionality in V5.0 to assist in this type of modeling. You can also refer to this blog entry: http://www.comsol.com/blogs/investigating-led-efficiency-via-multiphysics-simulation/ and these new models: http://www.comsol.com/model/ingan-algan-double-heterostructure-led-20299 http://www.comsol.com/model/gaas-pin-photodiode-19705

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.