Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

half cylinder

Posted 13.02.2014, 10:32 GMT-5 Version 4.3b 2 Replies

Arshad Salema
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,
Can any one please help me how to draw half cylinder. I mean which is cut exactly in middle i.e. half of the diameter. I had already draw the cylinder, but I do not know how to cut into half.

Thanks.
2 Replies Last Post 27.02.2014, 11:00 GMT-5
Sergei Yushanov Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 13.02.2014, 11:36 GMT-5
Arshad,

Attached is half cylinder.

Regards,
Sergei
Arshad, Attached is half cylinder. Regards, Sergei

Attachments:

Arshad Salema
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 27.02.2014, 11:00 GMT-5
Thank you very much Sergei.

regards,

Arshad
Thank you very much Sergei. regards, Arshad

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content