Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
mesh setting
Posted 15.01.2014, 11:27 GMT-5 Version 4.3b 1 Reply
Please login with a confirmed email address before reporting spam
Hello
I have a model which is a very thin film with a thickness of um and length of cm. I get convergence error when I simulate it with Heat Transfer module/Joule Heating! I think that I should use specific techniques for this structure specially in meshing. I attached my file for the film in thickness of 1mm which will not be converged if I change the thickness into um.
Does any body have any idea?
Thanks.
Regards
Elham
I have a model which is a very thin film with a thickness of um and length of cm. I get convergence error when I simulate it with Heat Transfer module/Joule Heating! I think that I should use specific techniques for this structure specially in meshing. I attached my file for the film in thickness of 1mm which will not be converged if I change the thickness into um.
Does any body have any idea?
Thanks.
Regards
Elham
Attachments:
1 Reply Last Post 16.01.2014, 06:27 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
Look at my simple model, where I have drawn just two blocks corresponding to your dimensions. Swept mesh seems to work.
BR
Lasse
Look at my simple model, where I have drawn just two blocks corresponding to your dimensions. Swept mesh seems to work.
BR
Lasse
Attachments: