Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Leakage channel fiber design to reduce bend loss and getting maximum effective area

Posted 27.09.2013, 10:02 GMT-4 RF & Microwave Engineering Version 4.2a 0 Replies

tanmaya
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

i am designing a leakage channel fiber to get low bend loss and large effective area.i design the 6 air hole one ring design and bent it,but i am not getting any solution in complex form so that i can calculate the loss.
0 Replies Last Post 27.09.2013, 10:02 GMT-4
COMSOL Moderator

Hello tanmaya

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content