Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Coefficient form PDE with Dirichlet boundary conditions - Problem with diffusion coef and source term
Posted 11.09.2013, 10:48 GMT-4 Materials, Results & Visualization, Studies & Solvers Version 4.2a 0 Replies
Please login with a confirmed email address before reporting spam
I have a Coefficient form PDE with Dirichlet boundary conditions with two dependent variables. The dependent variables range -5<v1<5 for v1 and 250<v2<600 for v2. The model converges quickly and gives expected results when the diffusion coefs are f(v2) [ie f(v2) = av2 + b] and the source term is a f(v1v2,v1^2).
When I try to make the source term f(v1^2,v2^3) or the diffusion coef f(v2^5) then I cannot get the computation to converge. v1 and v2 are well defined real numbers throughout the range of interest. Is there some kind of constraint I can implement to allow convergence?
I do not know how to create a domain for v1 and v2 to restrict them to possible values but suspect that that might allow for a solution.
I have tried different solvers and mesh sizes.
Absorption coef, mass coef, damping coef, cons flux coef, conv coef and cons flux source are all zero. The solution is stationary time invariant.
Hello Brian Geist
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.