Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

When is it OK to update a solution instead of resolving a solution?

Posted 26.06.2013, 16:06 GMT-4 Studies & Solvers Version 4.2a 2 Replies

Patrick Kirby
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am currently working on a model, and as most models this model has a large number of parameters. I'd like to model these parameters and see the results and was wondering if it is necessary to rerun the entire simulation or simply update the solution? If it matters I am trying to solve for laminar flow and would like to see the changes which result from changing the fluid viscosity. I am also working on solving mass transport and would like to do similar things with the parameters incorporated in that model.

Please advise

Thanks

Pat
2 Replies Last Post 26.06.2013, 17:42 GMT-4
Edgar J. Kaiser Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 26.06.2013, 16:39 GMT-4

Hi Pat,

if the parameters change the physically relevant geometry, material properties or boundary conditions you have to re-solve the model.

If you only add geometry elements like points, lines and surfaces for postprocessing (without a physical impact to the model, i.e. without adding boundary conditions) I think it is sufficient to update the solution. This will then make these entities available for selection in the post processing.

That's my two cents, I can't guarantee that it is the complete picture. In my modeling experience I never came across a parameter study that didn't require solving the model for each parameter dimension and parameter step.


--
Edgar J. Kaiser
www.emphys.com
Hi Pat, if the parameters change the physically relevant geometry, material properties or boundary conditions you have to re-solve the model. If you only add geometry elements like points, lines and surfaces for postprocessing (without a physical impact to the model, i.e. without adding boundary conditions) I think it is sufficient to update the solution. This will then make these entities available for selection in the post processing. That's my two cents, I can't guarantee that it is the complete picture. In my modeling experience I never came across a parameter study that didn't require solving the model for each parameter dimension and parameter step. -- Edgar J. Kaiser http://www.emphys.com
Patrick Kirby
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 26.06.2013, 17:42 GMT-4
Hey Edgar,

Thanks for your response! Your response seems very logical, and what I felt as well.

Thanks and have a good one!

Par
Hey Edgar, Thanks for your response! Your response seems very logical, and what I felt as well. Thanks and have a good one! Par

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content