Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Tube diffusion
Posted 26.06.2013, 10:59 GMT-4 Fluid & Heat, Computational Fluid Dynamics (CFD), Mesh Version 4.3b 1 Reply
Please login with a confirmed email address before reporting spam
Hello all,
So I have flow through a cylinder, and want to inject some sort of dye into it. I made a cylinder, and then extruded a circle on the edge to simulate the injection point where I will have some sort of inflow or flux of concentration. For some reason the mesh is not generating around the circle. I'm not sure if I did it right, but any suggestions would be helpful! I attached the file if anyone wants to look. Thanks!
Jon
So I have flow through a cylinder, and want to inject some sort of dye into it. I made a cylinder, and then extruded a circle on the edge to simulate the injection point where I will have some sort of inflow or flux of concentration. For some reason the mesh is not generating around the circle. I'm not sure if I did it right, but any suggestions would be helpful! I attached the file if anyone wants to look. Thanks!
Jon
Attachments:
1 Reply Last Post 04.07.2013, 08:45 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Dear Jonatan,
I'm working with a bit similar problem. I just made a sphere inside the flow with continuity boundary conditions for fluid and fix a reaction rate for diluted species. I have no problems with meshing for such a decision. Good luck
Evgeny
I'm working with a bit similar problem. I just made a sphere inside the flow with continuity boundary conditions for fluid and fix a reaction rate for diluted species. I have no problems with meshing for such a decision. Good luck
Evgeny