Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Doubts with induction heating

Nestor Bolaños Rodriguez

Please login with a confirmed email address before reporting spam

Hi, i'm designing an induction heating system applied for an FDM (Fused deposition modeling) extruder for my final proyect. I started using a ferritic stainless steel (430), which has a relative permeability of 850, to produce the heat and got good results (MAX T = 279ºC at 120s). However, when i used other materials with a similar permeability, such as Nickel (600) or even higher permeability, such as iron (4000) the was much less effective (Max T = 69.9 for Nickel and 79 for the same time). The simulation's result with the stainless steel seems to be anormal

am I doing something wrong or forgeting something or its just a failure of the program .

I attach some pictures of the different results


0 Replies Last Post 03.06.2013, 09:08 GMT-4
COMSOL Moderator

Hello Nestor Bolaños Rodriguez

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.