Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
shrinking and eventually disappearing mesh
Posted 13.05.2013, 19:50 GMT-4 0 Replies
Please login with a confirmed email address before reporting spam
I'm working a problem where a porous particle is being heated and vaporized. I am using moving mesh with a prescribed normal mesh velocity to shrink the solid domain of the particle (see attached figure).
The problem arises when the walls shrink to the point that boundaries are touching at some places, which should separate the particle into new, multiple sub domains or something. Then these domains would then continue shrinking until the entire particle is gone.
What's the best way to handle this in Comsol? Any advice is appreciated.
-Peter
Attachments:
Hello Peter Ciesielski
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.